Method of directly connecting door jambs

常规注意事项：

General precautions:

材料厚度必须保证1.2厚（实际厚度不得小于1.08）。

The material thickness must ensure a thickness of 1.2 (the actual thickness should not be less than 1.08).

必须注意用竖料来收口门头横料。

It is necessary to pay attention to using vertical materials to close the horizontal material of the door head.

注意制作基层一定要小于门套包边尺寸5mm左右，保证足够的空间安装和打胶。

Be sure to make the base layer smaller than the door pocket edge size by about 5mm to ensure sufficient space for installation and gluing.

门口板宽度要略小于竖料宽度1—2mm，收口才美观。

The width of the entrance board should be slightly smaller than the width of the vertical material by 1-2mm for a beautiful closure.

一般门头板和立面包板对接处的阴角处不建议用胶水收口，这样既美观又能检测门套安装质量。

It is not recommended to use glue to close the internal corners of the joint between the door header and the facade panel, as this not only looks beautiful but also checks the installation quality of the door cover.

二普通45°拼接门套做法

Method of making two ordinary 45 ° splicing door jambs

常规注意事项：

General precautions:

材料厚度建议1.2厚（实际厚度不得小于1.08）。注意对角处不能有错位，焊点处一定要处理在隐蔽位置。

The recommended material thickness is 1.2 (the actual thickness should not be less than 1.08). Note that there should be no misalignment at the corners, and the welding points must be handled in a concealed position.

注意制作基层一定要小于门套包边尺寸5mm左右，保证足够的空间安装和打胶。

Be sure to make the base layer smaller than the door pocket edge size by about 5mm to ensure sufficient space for installation and gluing.

一般门头板和立面包板对接处的阴角处不建议用胶水收口，这样既美观又能检验门套质量。

It is not recommended to use glue to close the internal corners of the joint between the door header and the facade panel, as this not only looks beautiful but also checks the quality of the door cover.

本文由菏泽拉丝不锈钢电梯门套线友情奉献.更多有关的知识请点击:http://www.nthly.cn真诚的态度.为您提供为全面的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

This article is dedicated by Heze Brushed Stainless Steel Elevator Door Cover Line. For more information, please click on: http://www.nthly.cn Sincere attitude. We will provide you with comprehensive services. We will gradually contribute more relevant knowledge to everyone. Stay tuned